Aluminium window and door finishes
Anodised, powder-coated and woodgrain — measured in light, not on a screen.
A finish is the first thing a project specifies and the last thing a building forgets. We ship physical sample chips with every quotation, free of charge, because hex codes on a screen are not aluminium in daylight. The libraries below are the standard schedule; every RAL in the chart is powder-coat available on all twenty-two systems.
Anodised
Mill-anodised aluminium, 15–20 µm, natural metallic grain.
Anodised Natural
Anodised Silver
Powder-coated RAL
Two-coat system, 80 µm, salt-fog schedule available for coastal projects.
Anthracite · RAL 7016
Graphite · RAL 7024
Jet Black · RAL 9005
Traffic White · RAL 9016
Cream · RAL 1015
Champagne · RAL 1019
Woodgrain transfer
PVC woodgrain film over powder base, interior or dual-side application.
Ash Natural
Walnut Dark
Bronze
Copper
The finish sits on three layers.
Bare extrusion, 6063-T5
The alloy itself — chambers, tightness, the engineering you never see.
Conversion + coating
Surface conversion, then anodise or two-coat powder at 80 µm, salt-fog tested.
Woodgrain film, optional
PVC transfer over the powder base, interior or dual-side, on top of any RAL.
Colour guide
One PDF, every swatch.
All 12 standard finishes with RAL references, coat systems and applicable systems — the reference our distributors pin next to the colour chips.
Anodised or powder-coated?
The short version is below; the full comparison lives in our drawing-office note, powder coating vs anodising for export windows.
| Anodised | Powder-coated | |
|---|---|---|
| Layer | Oxide grown from the metal, 15–20 µm | Polyester film, two coats, 60–80 µm |
| Colour | Metal tones — natural, bronze, grey, champagne | Any RAL, plus woodgrain transfer |
| Surface | Extrusion grain reads through | Flat, uniform colour |
| Abrasion | Oxide is harder than the base metal; handling marks show less | Softer film; small chips can be touched up |
| Repair | Not spot-repairable — the colour is the metal | Spot touch-up possible on small damage |
| Salt-spray | An added layer where the schedule calls for both | Specified at 480 h, up to 1,000 h marine |
| Relative cost | Lower per metre for plain silver and grey | Tracks colour and schedule |
| Best for | Slim-frame, natural-metal look; sparse-maintenance sites | Coloured façades, coastal work, woodgrain |
Finish questions we get
Which finish suits a coastal project?
Two-coat powder on the salt-spray schedule for coloured façades; anodised natural where the metal look is wanted and maintenance visits are sparse. Both run on all twenty-two systems, and a physical chip of each ships with the quotation.
Are the swatches on screen accurate?
No screen renders aluminium in daylight. The circles above are a starting point — the physical sample chips we post with every quotation are the reference.
Can I mix finishes across one project?
Yes. A common pairing is anodised natural on fixed glazing and a powder RAL on the opening sashes and doors, so the frame reads as metal while the moving parts carry the façade colour.